Fascia Repair and Replacement
Fascia board repair or replacement including plywood replacement and painting.
Kellum Roofing repairs and replaces fascia board on homes throughout Glendale, Peoria, Scottsdale and the Valley, including plywood replacement and finish painting. Fascia is the vertical board running along the roof edge, usually behind the gutter, and in Arizona it is the exterior wood that takes the worst of the sun. It is also the part of a house that most visibly ages a property from the street, which is why we get called about it as often for appearance as for damage.
What Fascia Does and Why It Fails Here
The fascia board caps the ends of the rafters or trusses at the roof edge. It gives the roof its finished line, it provides the mounting surface for the gutter, and together with the soffit it closes the roof structure off from the outside. In a wetter climate fascia fails from water. In Arizona it fails from sun. Sustained ultraviolet exposure and enormous daily temperature swings dry the wood out, break down the paint film, and open checks and splits in the surface. Once the paint is gone the wood is exposed directly, and the swings between a hot afternoon and a cold night work those splits wider. Then monsoon season arrives, water gets into the open grain and behind the gutter, and the sun bakes it. That cycle is what turns a sun faded board into a rotted one. The board that looks merely tired this year is often soft the following year.
Signs Your Fascia Needs Attention
Peeling, chalking or completely absent paint. Visible splits, checking or cupping along the board. Wood that gives when pressed, which means rot has started. Dark staining behind the gutter line. Gutters that have started to sag or pull away, which usually means the wood holding the fasteners has softened. Gaps opening between the fascia and the soffit, which are an entry point for birds, rodents and wasps. That last one comes up more than people expect. An open gap at the roof edge is an invitation, and the cost of dealing with what moves in is generally more than the cost of closing the gap.
Repair, Replace, or Both
Not every fascia run needs to come off. If the damage is localized to a section, the rest of the board is sound and the paint failure is limited, we can replace the affected sections and refinish the whole run so it reads as one continuous piece rather than a patch job. When rot has spread along a run, when the board has cupped badly enough that it will not hold paint or a straight gutter line, or when the fascia has been repaired repeatedly already, replacement of the full run is the right answer and usually the cheaper one over any reasonable time horizon. We often find the rot extends past the fascia into the plywood at the roof edge or into the rafter tails, in which case that gets addressed too. Putting a new board over rotted framing is a cosmetic fix on a structural problem.
Plywood and Roof Edge Work
Because fascia sits at the roof edge, fascia work and roof work overlap constantly. When water has gotten behind a failed fascia board, the sheathing at the edge of the roof deck is often the next casualty, and that is a roofing repair rather than a carpentry one. We replace damaged plywood at the roof edge as part of this service, and we make sure the drip edge and the roofing material terminate correctly over the new board. Doing fascia without addressing that termination is how the new board fails on the same schedule as the old one. This is also why fascia work pairs naturally with a tile roof replacement or shingle roof replacement. If the roof is coming off anyway, the edge is already exposed and the fascia is far cheaper to address at the same time than as a separate mobilization later.
Painting and Finish
We do not hand back bare wood. Fascia replacement includes priming and painting, matched to your existing trim color, because in this climate an unpainted or poorly painted board starts the failure cycle over immediately. The paint film is not decoration on an Arizona fascia, it is the only ultraviolet protection the wood has. Finish quality is where fascia work is visibly good or visibly bad from the curb. Clean lines, proper joints, and a full coating rather than a spray-and-go pass over the front face only.
What This Costs and What Drives It
Price depends on the linear footage involved, whether we are doing sections or full runs, the height and accessibility of the roof edge, how much plywood or rafter tail work we find once the old board is off, and the paint work. A single story ranch with one damaged run is a small job. A two story home with rot along multiple elevations is not. Because hidden damage is common on fascia, we quote the visible scope and flag the likelihood of additional plywood work rather than pretending we can see through a board. Jeremy would rather set that expectation up front than surprise you mid job.
Not sure what your roof needs?
Get a free inspection with photos from a licensed Glendale roofer. Call (480) 258-0925 or request an estimate online.
Free InspectionOther Services
We walk the roof, photograph what we find, and give you a written estimate, often the same day.
(480) 258-0925
Built to endure
Arizona heat.
BBB Accredited
Accredited Business since 2024.
Licensed, Bonded, Insured
Arizona ROC 352782, Specialty Dual.
Locally Owned
Based in Glendale. Not a franchise and not an out-of-state storm chaser.
Manufacturer Warranties
Underlayment warranties from 10 to 30 years.
Jeremy took care of the tile replacement and minor repairs in a timely manner and at a very fair price!! I would highly recommend Kellum Roofing!